Sharp UX-A260 - Manual (Page 23)

Setting the Reception Mode
21
1. Ins
tal
lati
on
Setting the Reception Mode
Your fax has three modes for receiving incoming faxes:
FAX mode:
Select this mode when you only want to receive faxes on your line. The fax
machine will automatically answer all calls on four rings and receive incoming
faxes.
TEL mode:
Select this mode when you want to receive both phone calls and faxes on the
line connected to the fax machine. All calls, including faxes, must be
answered by picking up the fax machine's handset or an extension phone
connected to the same line.
TAD mode:
Select this mode when you go out and want the built-in answering system to
answer all calls. Voice messages will be recorded, and fax messages will be
received automatically (“TAD” stands for “Telephone Answering Device”.)
Setting the reception mode
Make sure a document is not loaded in the document feeder, and then
press until the arrow in the display points to the desired mode.
RESOLUTION/
RECEPTION MODE
Note: TAD mode cannot be selected unless a general outgoing message has
been recorded as explained on page 24.
For more information on receiving faxes in FAX and TEL modes, see Chapter
4,
Receiving Faxes. For more information on using TAD mode, see Chapter 2,
Using the Answering System.
1
9
4 5 6
7 8
0
2 3 RESOLUTION/
RECEPTION MODE
RESOLUTION/
RECEPTION MODE
FAX TEL
JAN-01 10:30
FAX TEL
JAN-01 10:30
FAX TEL
JAN-01 10:30
TAD
TAD
TAD