Sharp UX-A260 - Manual (Page 65)

Optional Reception Settings
63
4. Rec
e
iv
ing
Fa
x
e
s
1
Press once and once.
2
Press once and 4 times.
3
Press once.
4
Press to turn on the function, or
to turn it off.
5
Press to return to the date and time display.
FUNCTION
1
2
STOP
Reception Ratio
The fax has been set at the factory to automatically reduce the size of
received documents to fit the size of the printing paper. This ensures that data
on the edges of the document are not cut off. If desired, you can turn this
function off and have received documents printed at full size.
♦
If a document is too long to fit on the printing paper, the remainder will be printed on
a second page. In this case, the cut-off point may occur in the middle of a line.
♦
Automatic reduction may not be possible if the received document is too large,
contains too many fine graphics or images, or is sent at high resolution. In this
case, the remainder of the document will be printed on a second page.
The display briefly shows
your selection, then:
CALLER-ID
Display:
OPTION SETTING
FAX SIGNAL RX
1=YES, 2=NO
Optional Reception Settings
Fax Signal Receive
Your fax will automatically begin reception if you hear a soft fax tone after
answering a call on your fax or an extension phone. If you use a computer fax
modem to send documents on the same line, you must turn this function off in
order to prevent your fax from mistakenly attempting to receive documents
from the computer fax modem. Follow the steps below to change the setting.