Ardo A1000X - Manual (Page 61)

SM1
✽
Under no circumstances should any
repairs to the machine be attempted
by unqualified persons as this could
result in serious damage and will
invalidate the guarantee.
✽
Repairs to the washing machine must
only be carried out persons authorised
to do so by the service centres. Only
original spare parts may be used for
repairs.
3
PREPARING THE MACHINE FOR USE
How to unpack and remove the protection devices
➘
Put the washing machine in its place of installation and remove the external packag-
ing.
➘
Unscrew the 4 protection screws anchoring the mobile parts marked with the letters A-B-
C-D in figures 1 and 2, and then remove them together with the plastic spacers H [fig. 2].
Insert the plugs supplied in the holes left by the screws.
➘
If the spacers remain in the machine, they can be removed by unscrewing the screws
indicated with the letter L in figure 2, and then finish by screwing the panel back in
place. The screws and spacers must be kept in a safe place for re-use when the
machine is moved in the future.
The spacers must be removed, in that if they are left in position they may cause
damage to the equipment.
➘
Lift the washing machine and remove the polystyrene base.
How to repack the machine
a) unscrew the 8 screws marked L from the rear panel and remove the panel.
b) insert the locking screws A-B-C-D in their respective holes.
c) insert the 4 spacers onto screws A-B-C-D of the panel.
d) locate the rear panel on the machine, ensure it is positioned correctly and then
tighten screws A-B-C-D.
e) replace and tighten the 8 rear panel screws marked L.