Ardo A1000X - Manual (Page 67)

SM1
ADDITIONAL FUNCTIONS (AVAILABLE ACCORDING TO MODEL)
- ON/OFF: To start the machine, pull the Timer knob outwards, or press the button if the
machine is fitted with one. The indicator light will light up.
−−−−− Temperature limit button:
Pushing this button will limit the temperature to 60°
when the temperature dial is set at a higher temperature. Symbol E.
−−−−− No-drain button:
When this button is pushed, the washing machine will stop auto-
matically at the end of the last rinse cycle and before draining the water. In this case,
the washing is held in the water-filled drum to prevent creasing. This function only
works for the delicate wash cycle. Symbol
−−−−− No-spin button:
The washing machine carries out a normal wash cycle but does not
spin. To do this, press the button with the symbol
−−−−− Economy wash button:
When the load to be washed is small (less than 3 kg),
push the low water consumption button with the symbol
−−−−− Additional rinse button:
The washer has been designed so that a minimum amount of water is used, usually
three rinse cycles are enough.
For areas with particularly soft water and for those who are allergic to detergent resi-
due, the washers are supplied with a button for an additional rinse cycle.
−−−−− 500/Max or spin speed button:
Push in for Max rpm. push in egain to release
switch for 500 rpm.
−−−−− Temperature control:
The temperature control allows you to set the required
temperature. The temperature is programmed by turning the dial clockwise ,
until the required temperature is reached. To set the correct temperature for the wash,
refer to the table of programmes on page 10 of the instructions for use.
−−−−− Spin rpm control dial:
This allows the spin speed to be selected
W
ARNING
: This is only available during intensive wash programmes. For delicates and wool,
the spin speed is 550 rpm regardless of the speed setting.
I
MPORTANT
:Any changes to the above programme and function settings must only be
made with the machine switched off, i.e. with the main switch in position 0.
9