SUPER MICRO Computer X6QTE+ - Manual (Page 72)

4-14
X6QT8/X6QTE+ User’s Manual
Terminal Type
This feature allows the user to select the target terminal type for Console
Redirection.The options are ANSI, VT100, and VT-UTF8.
VT-UTF8 Comb Key Support
This feature allows the user to select Enabled to enable the VT-UTF8 Combination
Key support for the ANSI/VT100 Terminals. The options are Enabled and
Disabled.
Sredir Memory Display Delay
This feature allows the user to decide how many seconds the BIOS shall wait
before memory information is displayed. The options are: No Delay, Delay 1
Sec., Delay 2 Sec. and Delay 4 Sec.
USB Confi guration
This feature allows the user to confi gure the USB settings.
USB Function
This feature allows you to enable the USB Ports. The options are Disabled, 2
USB Ports, 4 USB Ports, and Enabled.
Legacy USB Support
Select Enabled to enable USB Legacy support. Disable legacy support if there
are no USB devices installed in the system. The options are Disabled, Enabled,
and Auto.
USB 2.0 Controller
This setting allows you to enable or disable the USB 2.0 Controller. The options
are Disabled and Enabled.
USB 2.0 Controller Mode
This setting allows you to confi gure the USB 2.0 Controller Mode. The options are
Hi-Speed (480 Mbps) and Full Speed-(12Mbps).
Stop EHCI HC in OHCI Handover
Select Enabled to halt an ECHI Host Controller during OHCI OS handover calls
when the EHCI Host Controller is not supported by the Operating System.
Hot Plug USB FDD Support
Set to Enabled to create a dummy FDD device to be used as a hot-plug FDD.
Set to Auto for a hot-plug FDD device to be automatically created if a USB FDD
is not detected. The options are Auto, Enabled and Disabled.