SUPER MICRO Computer X6QTE+ - Manual (Page 99)

Appendix C: Software Installation
C-11
Initializing Disk Drives
If an installed disk does not appear in the disk selection list for creating a new ar-
ray, or if it appears grayed out, you may have to initialize it before you can use it
as part of an array. Drives attached to the controller must be initialized before they
can be used in an array.
Caution: Initializing a disk overwrites the partition table on the disk and makes any
data on the disk inaccessible. If the drive is used in an array, you may not be able
to use the array again.
Do not initialize a disk that is part of a boot array. To determine which disks are
associated with a particular array, please refer to Viewing Array Properties.
To initialize drives:
1. Turn on your computer and press Ctrl+A when prompted to access the ARC
utility.
2. From the ARC menu, select Array Confi guration Utility (ACU) (as shown in
the screen below).
3. Select Initialize Drives (as shown in the screen below).