Sony LMD-1950MD - Manual (Page 14)

Removing the Connector Cover / Selecting the Default Settings
14
Removing the
Connector Cover
When the unit is shipped from the factory, a connector
cover is attached to the PARALLEL REMOTE terminal
(connector).
To use the connector, remove the connector cover as
follows.
Before removing the connector cover, disconnect the
power cord.
1
Remove the screw of the connector cover.
2
Remove the connector cover.
Save the screw and cover, so that you can reattach the
cover if necessary.
Caution
This connector is designed to allow direct contact with
conductive circuits. Weak voltage may be present
because of a failure in this unit. To prevent patients from
touching this connector accidentally, attach the
connector cover when the connector is not being used to
connect to other devices.
Selecting the Default
Settings
When you turn on the unit for the first time after
purchasing it, select the area where you intend to use this
unit from among the options.
The default setting values for each area
Connector cover
COLOR
TEMP
COMP
LEVEL NTSC
SETUP
1 NORTH AMERICA Low BETA7.5 7.5
2 LATIN AMERICA
PAL&PAL-N AREA
ARGENTINA Low SMPTE 0
PARAGUAY Low SMPTE 0
URUGUAY Low SMPTE 0
NTSC&PAL-M AREA OTHER AREA Low BETA7.5 7.5
3 AFRICA AUSTRALASIA
EUROPE MIDDLE-EAST
Low SMPTE 0
4 ASIA EXCEPT JAPAN
NTSC AREA Low BETA7.5 7.5
PAL AREA Low SMPTE 0
5 JAPAN High SMPTE 0
3
3
4
5
3
1
2
+
–
+
–
MENU ENTER INPUT
R
USER MEMORY +
–
+
–
-