Sony DHC-MD5 - Manual (Page 6)

6
DHCMD5 3-858-048-11 (1)EN
Step 3: Presetting
radio stations
You can preset up to 40 stations, 20 for FM, 10
for MW and 10 for SW. For tourist model,
you can preset up to 30 stations, 20 for FM
and 10 for AM.
6
Turn MULTI JOG and select the
preset number you want.
7
Press ENTER/YES.
The station is stored.
8
Repeat steps 1 to 7 to store other
stations.
To tune in a station with a weak
signal
Press TUNING MODE repeatedly until
“MANUAL” appears in step 2, then turn
MULTI JOG to tune in the station.
To change the preset number
Start again from step 1.
To change the MW (AM) tuning
interval (except for Middle
Eastern model)
The MW (AM) tuning interval is factory-
preset to 9 kHz (10 kHz in some areas). To
change the MW (AM) tuning interval, tune in
any MW (AM) station first, then turn off the
power. While holding down the ENTER/
YES button, turn the power back on. When
you change the interval, all the MW (AM)
preset stations will be erased. To reset the
interval, repeat the same procedure.
Tip
The preset stations are retained for a week even if
you pull out the mains lead or if a power failure
occurs.
1
Press TUNER/BAND repeatedly
until the band you want appears in
the display.
Each time you press the button, the band
changes as follows:
Tourist model:
FM nAM
Other models:
FM n MW n SW
2
Press TUNING MODE repeatedly
until “AUTO” appears.
3
Turn MULTI JOG.
The frequency indication changes and
scanning stops when the system tunes in
a station. “TUNED” and “STEREO” (for
a stereo program) appear.
4
Press EDIT/NO, then turn MULTI
JOG until “Frq-Memory?” appears.
5
Press ENTER/YES.
Preset number
® ∏ · π §
º ‚
3,6 5,7 2 1 4