Sony HT-DDW685 - Manual (Page 24)

24 GB
Tips
• You can also fix the optimizer microphone to a
tripod (not supplied) and place the tripod at your
listening position.
• Be sure to remove any obstacles in the path
between the optimizer microphone and the
speakers.
• When you face the speaker towards the optimizer
microphone, you will get a more accurate
measurement.
Press AUTO CAL.
The following appears on the display.
A.CAL [5]
t A.CAL [4] t A.CAL [3] t
A.CAL [2] t A.CAL [1]
The measurement process will take a few
minutes to complete.
The table below shows the display when
measurement starts.
* The corresponding speaker indicator lights up in
the display during measurement.
When measurement ends, “COMPLETE”
appears on the display and the settings are
registered.
After you have finished
Disconnect the optimizer microphone from the
receiver.
Notes
• Auto Calibration cannot detect the sub woofer.
Therefore, the sub woofer settings will be
maintained.
• You cannot select Auto Calibration when the
headphone is connected.
Tips
• When Auto Calibration starts:
– Stand some distance away from the speakers and
the listening position to avoid measurement
failure. This is because test signals are output
from the speakers during measurement.
– Avoid making noise to get a more accurate
measurement.
• The Auto Calibration function will be canceled
when you do the following during the
measurement process:
– Press ?/1, input buttons or MUTING.
– Change the volume level.
– Press AUTO CAL again.
Performing Auto Calibration
1 2 3
4 6
7 8
0/10 ENTER
9
SYSTEM STANDBY
TV INPUT
SLEEP
AUTO
CAL
TV ?/1
AV ?/1
VIDEO 1 VIDEO 2 VIDEO 3 DVD
2CH A.F.D.
RETURN/EXIT MENU
MOVIE MUSIC
MEMORY DVD MENU
CLEAR
TOOLS DISPLAY MUTING
TV VOL
MASTER VOL
FM MODE
D.TUNING
D.SKIP
AMP MENU
SAT TV SA-CD/CD TUNER
?/1
-
F
G g
f
5
>10/
Input
buttons
?/1
switch
MUTING
MASTER
VOL +/–
AUTO
CAL
Measurement for Display
Environment noise level NOISE.CHK
Speaker connection MEASURE and SP
DET. appears
alternately*
Speaker level MEASURE and
GAIN appears
alternately*
Speaker distance MEASURE and
DISTANCE appears
alternately*