Woodstock SHOP FOX W1715 - Manual (Page 22)

-20-
N(.(,Fne\i jDXelXc D]^%J`eZ\)&'/
FG
<
I
8
K@FEJ
M\ik`ZXcFg\iXk`fe
The Model W1715 can easily be set up for vertical cutting
operations to make cuts that are not a straight cut
through the entire workpiece, such as curves or pattern
cuts.
KfXjj\dYc\k_\YXe[jXn]fim\ik`ZXcZlkk`e^#[fk_\j\
jk\gj1
(% DISCONNECT BANDSAW FROM POWER!
)% Remove the two flat head screws and the blade
guide cover shown in =`^li\)*.
*% Install the table and replace the two screws removed
in Jk\g).
+% Install the table bracket with the pre-installed hex
bolt, the M6-1 x 12 flat head screw, and the M6-1
hex nut, as shown in
=`^li\)+.
,% Place a level on the table, as shown in =`^li\),,
then use the adjustment bolt shown in =`^li\)- to
make the table level.
=`^li\)*% Blade guide cover.
Blade
Guide
Cover
=`^li\)+% Table and table bracket
installed.
Bolt Already
In Casting
=`^li\),% Adjusting table with a level.
=`^li\)-% Table adjustment bolt.
Adjustment
Bolt