Woodstock SHOP FOX W1715 - Manual (Page 24)

-22-
N(.(,Fne\i jDXelXc D]^%J`eZ\)&'/
FG
<
I
8
K@FEJ
The vise is designed to secure the workpiece during
horizontal cutting operations. Always use the vise when
cutting with the bandsaw in the horizontal position.
KffcjE\\[\[ Hkp
Machinist's Square ..............................................1
Kflj\k_\m`j\fepfliYXe[jXn#[fk_\j\jk\gj1
(% DISCONNECT BANDSAW FROM POWER!
)% Check the vise with a machinist's square to make sure
the vise is perpendicular to the blade and reads 0˚ on
the scale as shown in
=`^li\)0.
*% When the vise is square to the blade, place the
material to be cut between the vise jaws.
+% Turn the vise crank handle (=`^li\ *') clockwise to
firmly secure the workpiece in the vise jaws. The
workpiece is now ready to cut.
Lj`e^k_\M`j\
=`^li\)0% Using a machinist's square to
adjust the vise perpendicular to the blade.
Scale
=`^li\*'% Vise crank handle.
Vise Crank
Handle
The vise can hold workpieces for angle cuts ranging from
0˚ to 60˚.
KffcjE\\[\[ Hkp
Wrench or Socket 14mm .......................................1
KfX[aljkk_\m`j\]fiXe^c\Zlkj#[fk_\j\jk\gj1
(% DISCONNECT BANDSAW FROM POWER!
)% Loosen the hex bolts on the stationary vise jaw, as
shown in =`^li\*(.
*% Rotate the sliding edge of the vise to the desired
angle, indicated by the scale, and secure the bolts.
+% Place the workpiece between the jaws and clamp
firmly.
Efk\1 K_\m`j\aXnfek_\c\X[jZi\ng`mfkj]i\\cpkf
dXkZ_k_\Xe^c\f]k_\fk_\iaXn%
:cXdg`e^8e^c\j
=`^li\*(% Loosening vise hex bolts.
Hex Bolts