SUPER MICRO Computer MIIC-203 - Manual (Page 37)

38
// Status Display
/B[0|1|2] RS-232 Baud Rate Control (0=19.2, 1=57.6, 2=115.2KHz)
/C Close I2C Connection
/Dxx Set Destination I2C Slave Address
/E[0|1] Echo/Prompt Control (0=Disable, 1=Enable)
/F[0|1] Flow Control (0=XON/XOFF, 1=RTS/CTS)
/G[0|1] General Call Control (0=Disable, 1=Enable)
/H[0|1] Hex Only Display Control (0=Disable, 1=Enable)
/Ixx Set iPort/AFM’s Own I2C Slave Address
/K[0|1|2|3] I2C Bus Clock Rate Control (0=23, 1=86, 2=100, 3=400 KHz)
/M Menu Display
/N([0|1|A|R]) iNterrupt Signal Monitor/Control/Status
(0=Disable, 1=Enable / A=Assert, R=Release / <CR>=Status
/O Open I2C Connection
/(*)Rn Master Rx Message *=No Stop
/S(text) Slave Tx Message
/(*)T(text) Master Tx Message *=No Stop
/Un Set I2C Bus Time-oUt in msec 0=Disable)
/V Display Firmware Version (Major XX.XX Minor)
/X[...]... Extended Cmds (See Prompt or User’s Guide)
/Y Display Tx bYte Count
Interrupt Signal Control/Status
___
The INT signal allows the iPort/AFM to participate in INT master and/or slave
communications.
Command: /N0[CR] Disable Monitor
/N1[CR] Enable Monitor
/NA[CR] Assert INT Signal
/NR[CR] Release INT Signal
Response: *
Default Setting: /N0
, /NR
Open I
2
C Connection
This command activates iPort/AFM as an active device on the I
2
C Bus.
Command: /O[CR] 'Open I
2
C Connection
Response: /OCC[CR] 'Open Connection Complete
Default Setting: Closed