Sony BVM-D20F1U - Manual (Page 55)

49
Chapter 2 Menu
[C6] ALIGNMENT menu (1/3)
Adjust the position or size of the picture with the UP
and DOWN buttons or PHASE knob.
ROTATION: Compensates for the screen rotation
which occurs when the monitor is installed facing
north or south.
H PHASE: Adjust the horizontal picture position.
V CENTER: Adjust the vertical picture position.
H SIZE: Adjust the width of the picture.
V SIZE: Adjust the height of the picture.
VITS BLK: Adjust vertical blanking so that VITS
signals are not visible in the upper part of the
screen.
SUB CONTRAST: Adjust the center value of the
contrast when the image size or signal format is
changed.
[C6] ALIGNMENT menu (2/3)
Adjust the geometry of the picture with the UP and
DOWN buttons or PHASE knob.
H PIN: Correct side pincushion distortion.
H PIN BAL: Correct the balance of side pincushion
distortion.
H CORNER PIN: Correct pincushion distortion at the
sides of the picture.
H CORNER S: Correct S pincushion distortion at the
sides of the picture.
H KEY: Correct trapezoid distortion.
H KEY BAL: Correct the balance of trapezoid
distortion.
[C6] ALIGNMENT menu (3/3)
Adjust the convergence with the UP and DOWN
buttons or PHASE knob.
V STATIC CONV: Adjust vertical static convergence
on the whole screen.
V CONV TOP: Adjust vertical convergence at the top
of the screen. (BVM-D20F1U/D20F1E/D20F1A/
D24E1WU/D24E1WE/D24E1WA only)
V CONV BOT: Adjust vertical convergence at the
bottom of the screen. (BVM-D20F1U/D20F1E/
D20F1A/D24E1WU/D24E1WE/D24E1WA only)
H STATIC CONV: Adjust horizontal static
convergence on the whole screen.
CONV FINE ADJUST... : Adjust the convergence
finely at each adjustment point on the screen.
÷[C61] (BVM-D32E1WU/D32E1WE/
D32E1WA only)