Sony BVM-D20F1U - Manual (Page 15)

9
Chapter 1 Overview
Each decoder adaptor can be installed in any input
option slot.
Note
Turn off the main power of the monitor and disconnect
the AC power cord before installing or removing
adaptors.
1
Remove the cover of an input option slot on the
rear panel of the monitor.
2
Insert the adaptor under the positioning mark on
the top of the slot (on the left of the screw hole).
Installing a Decoder Adaptor
3
Push the adaptor in until it is firmly seated in the
connector inside the monitor, then tighten the two
screws to secure the adaptor.
Note
When installing a decoder adaptor in an input option
slot on the rear of the monitor, or fitting a cover plate
to an unused slot, always do such operation in order
from the rightmost slot. If some adaptors are already
installed, first of all remove them and then do the
installing operation in order from the rightmost slot.
When removing the adaptors, always loosen all
adaptor screws and then remove the adaptors in order
from the rightmost slot.
Cover of an input
option slot
Positioning mark
Insert the
adaptor here.
Make sure the MAIN POWER switch
is turned OFF, and disconnect the AC
power cord.