Sony DAV-FX900W - Manual (Page 25)

Getting Star
ted – AD
V
ANCED –
25 US
1
Prepare screws (not supplied) that are
suitable for the hole on the back of
each speaker. See the illustrations
below.
2
Fasten the screws to the wall.
For the front and surround speakers
3
Hang the speakers on the screws.
Note
• Use screws that are suitable for the wall material and
strength. As a plaster board wall is especially fragile,
attach the screws securely to a beam and fasten them
to the wall. Install the speakers on a vertical and flat
wall where reinforcement is applied.
• Contact a screw shop or installer regarding the wall
material or screws to be used.
• Sony is not responsible for accident or damage
caused by improper installation, insufficient wall
strength or improper screw installation, natural
calamity, etc.
Installing the IR transmitter
on a wall
You can hang the IR transmitter on a wall when:
– there is an obstruction between the IR
transmitter and IR receiver of the surround
speaker (L).
– people often pass between the IR transmitter
and IR receiver of the surround speaker (L).
When hanging both the IR transmitter and
surround speaker (L), adjust the position of the
IR transmitter after deciding the position of the
surround speaker (L).
1
Rotate the stand of the IR transmitter.
2
Install 2 commercially available screws in
the wall so that it protrudes 4 mm (
3
/
16
inch).
Install the screws 30 mm (1
3
/
16
inch) apart.
Installing the Speakers
and the IR transmitter on a
Wall
30 mm (1
3
/
16
inch)
4 mm (
5
/
32
inch)
Hole on the back of
the speaker
4.6 mm
(
3
/
16
inch)
10 mm
(
13
/
32
inch)
8 to 10 mm
(
11
/
32
to
13
/
32
inch)
330 mm
(13 inch)
4.6 mm
(
3
/
16
inch)
10 mm
(
13
/
32
inch)
Stand
IR transmitter
continued