Sony UP-CR20L - Manual (Page 18)

18
Loading the Paper Roll and Ink Ribbon
Chap
te
r 2
Pr
epa
ra
tio
n
s
Be sure to clean the inside of the printer before printing
(page 50).
Unlocking the Ribbon Door
The ribbon door is locked for safety when the unit is turned
on. To unlock the door, proceed as follows and display the
administration screen.
1
Turn on the power and start the unit.
The Start Guide screen appears.
If an ink ribbon or paper roll is not loaded, the
following error message appears.
2
Touch the top left corner of the screen twice in
succession.
The password entry screen appears.
3
Enter the administrator password using the numeric
keypad, and touch [OK].
(The factory default setting for the password is
“9999.”)
The administration screen appears.
When the administration screen appears, the ribbon
door will unlock.
Loading the Paper Roll and Ink
Ribbon
When you use the unit for the first time, load the paper roll
and ink ribbon.
To load the paper roll
• Be sure to remove the output cover, output tray, and
scrap receptacle before loading the paper roll.
Notes