Sony SU-PF1L - Manual (Page 7)

7
(US)
Install the Display Unit
WARNING
If you allow the Power Cord to be pinched under or between pieces of equipment, this may result in a short
circuit or an electric shock.
If you stumble over the Power Cord or the Display Interface Cable, the stand may topple over, and cause injury.
Draw the Power Cord and the Display Interface Cable through the hole on
the stand.
Decide on the installation location and lay the stand down before installing the Display Unit.
Since the Display Unit is heavy, it is recommended that you decide on the installation location beforehand and
lay the stand down there before installing the Display Unit on the stand.
Note
Do not push or pull the stand while it is on the floor. The rubber footings on the base of the stand may come off.
1
Connect the Power Cord and the Display Interface Cable to the Display
Unit.
z Tip
See the instruction manual of Flat-Panel Color Television (KDE55XBR950/KDE61XBR950) for more details
on connecting the Power Cord and the Display Interface Cable.
Notes
• If the weight of the Display Unit is placed on the speakers, deformation or a loose connection of the
speakers may result. To avoid this, observe the following.
– Do not hold the speakers when carrying the Display Unit.
– When connecting cables to the Display Unit, place packing material, etc. on the floor and lay the
Display Unit face down on it so that the speakers on either side of the Display Unit are clear of the
packing material, etc.
• Be sure to place the Display Unit stably.
• Use soft cloth to protect the screen of the Display Unit from damage or dirt.
Rear side of the Display Unit
Soft rag
Power Cord
Display Interface Cable
Speaker (right)
Packing material,
etc.
Speaker (left)