Samsung SVR-440 - Manual (Page 43)

43
. REMOTE CONTROLLER ID : Set the remote control ID. If you select 0, it appears R:A on the
screen and user can control all the DVRs by using only one remote controller
4.7 NETWORK & SERIAL SETUP
This is a set up menu related to Network and RS-485/422. Press the MENU button and select
the Tab by using the Left/Right button. Then, the submenu related to Network and serial
communication appears as illustrated below. Press button and select the submenu by using
the Left/Right button. Next, press button again, and you can select setup items by using the
Up/Down button.
4.7.1 NETWORK
Set the necessary items for network connection to a computer.
. NETWORK TYPE [ADSL/LAN/DHCP] : Selects the network types connected to a computer.
. IP ADDRESS: Enters [IP ADDRESS] that the relevant Internet service provider assigns to a user.
. SUBNET MASK: Enters [SUBNET MASK] address that the relevant Internet service provider
assigns to a user.
. GATEWAY: Enters [GATEWAY] Address that the relevant Internet service provider assigns to a
user.
. DNS: Enters [DNS] address that the relevant Internet service provider assigns to a user.
. ID: Enters a User ID registered within the relevant service provider.
. PW: Enters a User Password registered within the relevant service provider.
. DDNS SERVER ON/OFF: When DVR is connected to dynamic IP, the IP address changes every
time it attempts to connect to ISP. In this case, there is no way for a user
to know the changed IP address. If DVR that uses a dynamic IP address is
registered with its domain name, the domain name can be easily found
and can be connected even if the IP changes.