Sony CHC-TB10 - Manual (Page 18)

18 GB
Sound Adjustment
Adjusting the sound
Enjoying the powerful sound
— GROOVE
You can listen to music with more powerful
sound.
Press GROOVE.
“GROOVE” appears in the display and the
volume switches to power mode.
Press again to cancel GROOVE.
Tip
GROOVE is factory set to on.
Selecting the surround effect
Press SURROUND.
“SURROUND” appears in the display.
Press again to cancel SURROUND.
Adjusting the bass
1
Press BASS (or press TONE on the
remote repeatedly until “BASS”
appears).
2
Slide the knob to . or to > (or
press . or > on the remote)
repeatedly to adjust the bass.
You can adjust the bass in 11 steps (from –5
to + 5).
Timer-recording radio programs
(continued)
To Do this
Activate/check the
setting Press CLOCK/TIMER
SELECT on the remote and
press . or > on the
remote to select “REC”, then
press ENTER.
Change the setting Start over from step 1.
Cancel the timer Press CLOCK/TIMER
SELECT on the remote and
press . or > on the
remote to select “OFF”, then
press ENTER.
Notes
• When you use the recording timer at the same time
as the Sleep Timer, the Sleep Timer setting has
priority.
• You cannot activate the Daily Timer and the
recording timer at the same time.
• The system automatically turned on about 15
seconds before the preset time. Do not operate the
system until the recording starts.
• If the system is on about 15 seconds before the
preset time, the timer-recording will not be
activated.
• The volume is reduced to minimum during
recording.