Sharp AR-163 User Manual
Page 65
63
OPTIONAL EQ
UIPMENT
Erase
This copier has an edge erase mode and a centre erase mode.
●
Edge erase can be used to eliminate shadow lines around the edges of
copies caused when thick paper or a book is used as an original.
●
Centre erase can be used to eliminate the shadow produced by the
bindings of bound documents.
●
Edge + centre erase can be used to eliminate shadow lines around the
edges of copies and to eliminate the shadow at the centre of copies.
●
The erase width can be set from 0 to 20 mm (0" to 1") in five steps using
user program No. 16. See page 35.
●
This feature cannot be used with the 2 in 1 or 4 in 1 feature.
1
Place the original on the original table and close the
platen cover.
●
If an optional SPF is installed, it can also be used for this feature.
2
Press the ERASE (
/
) key to select the desired
erase mode.
●
To select the EDGE + CENTRE ERASE mode, press the ERASE
(
/
) key until both the EDGE (
) and CENTRE
(
) indicators light up.
3
Check the copy paper size.
●
The bypass tray and any tray with non-standard size paper cannot be
used for this feature.
●
If an optional paper feed unit is installed, use the TRAY SELECT
(
) key to select the desired paper size.
ELECTRONIC SORTING KIT (AR-EB3)
A B
A B
A
A
A B
A B
Centre erase
Edge + Centre erase
Edge erase
Electronic sorting kit (AR-EB3)