Appendix a – points to remember – SmartBridges sB3010 User Manual

Page 73

Advertising
background image

Page 73 of 82

i n t e l l i g e n t w i r e l e s s p l a t f o r m

airHaul™ Nexus User Guide

Appendix A – Points to Remember

Antenna

Frequency support

•

5GHz antennas will work between 5.2 and 5.8 GHz.

•

2.4 GHz band antennas will work between 2.4 GHz to 2.485 GHz

Gain

•

5 Ghz band antenna gain is 23 dBi.

•

2.4 Ghz band antenna gain is 24 dBi

•

29 dBi gain antenna is also available in request

Beamwidth

•

-3 dB Beam Width 10º -5GHz band antenna

•

-3 dB Beam Width 8º - 2.4 GHZ band antenna

Polarization:

•

Polarization -Linear Horizontal or Vertical

•

Factory assembled sB antennas are vertically polarized.

•

Polarity can be changed from vertical to a horizontal polarity by rotating the dish.

Mode of Operations

Different Modes of Operation

•

Root Device

- Root Bridge Mode.

•

Remote Device

- Remote Bridge Mode

- Remote Router Mode

Bridge mode

•

Device will act as a transparent bridge and will operate in Mac layer.

•

Bridge mode association is based on channel and MAC authorization only. ESSID will not

be used for the setting up a link.

•

If the remote client is configured in a bridge mode and channel needs to be changed then

channel needs to be changed at both the radios.

Router mode

•

Device will operate in layer 3 to perform routing. It is pure routing and network provider

has to take care of proper routing as there is no NAT feature in airHaul.

•

In a Router mode, the association is based on SSID.

•

Remote device configured in a Router mode will automatically follow the Root Bridge for

any change in channel. For this reason, the Remote Router mode is preferred. Please

select a channel with low interference for setting up a link in the beginning.

Radio

•

Transmit power – can be varied between -5 dBm to +23 dBm

•

To achieve high distance and high throughput at low EIRP (33dBm as per ETSI) a high

gain antenna (29 dBi) with low transmit power of the radio is recommended.

•

Setting up a radio at high Transmit power may result into Amplifier saturation, radio tends

to distort EVM. So we suggest that you try to use lower than the maximum power level.

•

Maximum recommended Transmit power in 5GHz band is 18dBm and in 2.4 GHz band it

is 20 dBm

Advertising