SmartBridges sB3010 - Manual (Page 74)

Page 74 of 82
i n t e l l i g e n t w i r e l e s s p l a t f o r m
airHaul™ Nexus User Guide
• Transmit power and RSSI are important criteria for getting a stable link
Throughput Optimizer
• The default value for the Throughput Optimizer is 6
• Throughput Optimizer settings is used to optimize the wireless link throughput
• Smaller "Throughput Optimizer" value means more stable link
Performance
The primary reason for implementing RTS/CTS is to minimize collisions and retransmission in a highly
overcrowded
.
Fragmentation
• Fragmentation can be used to avoid retransmission of the packets.
• The fragment size value can typically be set between 256 and 2,048 bytes.
• Fragmentation can improve throughput if the fragmentation threshold is set just right
value.
Range
• Maximum range of sB3010 is 20 Miles
• 6 Miles can easily achieved with 23 dBi antenna
• More than 6 miles can be achieved by using high gain antennas.
RSSI
• Recommended RSSI value of -75 dB or better for optimal performance .
Profile manager
• With Profile manager one can save/load multiple Operating profiles on the device.
• The Profile Calendar will automatically activate them at defined times.
• Optimal bandwidth utilization of the bandwidth on the basis of various time intervals as
per the traffic pattern of the customer can be achieved through pre-scheduling of profiles
Bandwidth Controller
• Bandwidth Controller will define the Maximum upload Wireless Throughput (Kbps) for a
radio.
• Maximum bandwidth capping for sB3010 is 15 Mbps
Link Test
• Web based ping test and throughput test option is available for testing a link .
Association of Radio
• In the 5 GHz band, due to DFS requirements (avoidance of interfering with Military
Radar), there might be a time delay in association of a radio. Usually it will associate
within 1 minute.
• For few channels the radios is required to sense the channel for a full one minute before it
will even send out a beacon for setting up a link