Samson UT-5 - Manual (Page 11)

9
Guided Tour - UR-5/UR-5D
Rear Panel
3: Unbalanced output* - Use this unbalanced high impedance (5K
Ohm) 1/4” jack when connecting the UR-5 or UR-5D to consumer (-10)
audio equipment. Wiring is as follows:
4: Output Mixing switch (UR-5D receiver only) - When on, the outputs
from both receivers are mixed together equally into a single monophonic
signal which appears at both sets of balanced and unbalanced outputs.
5: Rear-mount antenna knockouts - The receiver antennas can
optionally be mounted at these areas of the rear panel. Contact
Samson Technologies for information about our rear-panel antenna
mounting kit.
* If required, both the balanced and unbalanced outputs can be used
simultaneously.
+ SIGNAL
GROUND
+ SIGNAL
GROUND
SAMSON
SAMSON TECHNOLOGIES CORP.
HICKSVILLE, NEW YORK, U.S.A.
UHF SYNTHESIZED DIVERSITY RECEIVER 120V~ 50 / 60Hz 17W POWER
RATING
UNBALANCED
OUTPUT
-10dBv.5K
Ω
MODEL No.UR-5D AC INPUT
( 120V-240V VOLTAGE SENSING)
BALANCED
OUTPUT
-10dBm.600
Ω
UNBALANCED
OUTPUT
-10dBv.5K
Ω
BALANCED
OUTPUT
-10dBm.600
Ω
RECEIVER 2 RECEIVER 1
OUTPUT MIXING
ON OFF
1 2 3 5 5 2 3 4