Samson UT-5 - Manual (Page 27)

25
UT-5 Multi-pin Lavalier
Wiring Guide
The UT-5 transmitter can be used with a wide range of lavalier micro-
phones, headset microphones and instruments (such as electric guitar
or bass). The illustration below shows the wiring connections for its
multi-pin input connector:
Samson Technologies offers the following pre-wired input accessory
cables for the UT-5:
Part Number Description
————————————————————————————————
GC-1
Instrument cable, suitable for use with electric guitar or
bass, etc. Terminates at standard 1/4” phone plug.
MC-1
Low-impedance microphone cable, suitable for use with
most dynamic and condenser microphones.
Terminates at standard 3-pin XLR plug.
We offer the following lavalier microphones, available pre-wired for use
with the UT-5: Sony ECM-44, ECM-55, ECM-77; Sennheiser MKE-2;
Audio Technica 831C.
We also offer the following headsets, available pre-wired for use with
the UT-5: AKG C-410; Audio-Technica AT-71B; and Countryman
IsoMax.
For information about connecting other lavalier microphones and
headsets to the UT-5, refer to the chart on the following two pages.
SMALL DIAMETER LAVALIER WIRE
LARGE OUTER
STRAIN RELIEF
PLUG CASE
SLEEVE
SMALL INNER
STRAIN RELIEF