Sony DVP-CX995V - Manual (Page 83)

83
Settings
and Adjus
tments
Settings for the Speakers
(SPEAKER SETUP)
To obtain the best possible surround sound,
set the size of the speakers you have
connected and their distance from your
listening position. Then use the test tone to
adjust the volume and balance of the speakers
to the same level.
This setting is effective when connecting a
speaker with 5.1 CH OUTPUT jacks (page
24).
Select “SPEAKER SETUP” in the Setup
Display. To use the display, see “Using the
Setup Display” (page 76).
The default settings are underlined.
To return to the default setting
Select the item, then press CLEAR. Note that
only the “SIZE” setting does not return to the
default setting.
◆ SIZE
Selects the size of the speakers.
• FRONT
• CENTER
• REAR
• SUBWOOFER
Notes
• If your speakers are too small to reproduce low
bass frequencies, utilize a subwoofer for low
frequency sound. When you set the speaker
settings to “SMALL,” the bass redirection
circuitry will be activated and the bass
frequencies for the speakers are output from the
subwoofer.
• Even if there are fewer than 6 speakers connected,
the player distributes the audio signal components
to the front speakers.
• When you set the front speaker setting to
“SMALL,” you cannot set the center and rear
speaker settings to “LARGE,” and the subwoofer
setting to “NONE.”
LARGE Normally select this position.
SMALL Select this when the speaker
cannot reproduce adequate bass
frequencies.
LARGE Normally select this position.
SMALL Select this when the speaker
cannot reproduce adequate bass
frequencies.
NONE Select this if you do not connect
a center speaker.
SPEAKER SETUP
DISTANCE:
LEVEL(FRONT):
LEVEL(REAR):
OFF TEST TONE:
FRONT:
CENTER:
YES
LARGE
LARGE
LARGE
REAR:
SUBWOOFER:
SIZE:
LARGE Normally select this position.
Select according to the rear
speakers position.
SMALL Select this when the sound
distorts or the surround effects
are difficult to hear.
Select according to the rear
speaker position.
NONE Select this if you do not connect
rear speakers.
YES Select this if you connect a
subwoofer to output the LFE
(low frequency effect) signals
from the subwoofer.
NONE Select this if you do not connect
a subwoofer.
c continued