Siemens SIMATIC TIWAY 1 - Manual (Page 207)

UNILINK HOST ADAPTER F–1
USER MANUAL
APPENDIX F
MACRO DEFINITIONS FORM
Table F–1 is a worksheet for planning macro buffer requirements. The labels at
the top match the macro definitions with the particular network and adapter.
They are:
Network Enter the name used to describe the network with this
Name adapter.
Location Enter the location of the network and/or the adapter. This could be
the department in a plant, a plant, or any other definition.
UNILINK The address or other identifier that specifies this adapter.
Host
Adapter
The form columns are
Macro Enter the buffer number returned by the ALLOCATE
Buffer MACRO STORAGE BUFFERS command which numbers
Number the buffers sequentially beginning with 01 hex.
Command Enter the length in bytes for the macro command buffer.
Buffer
Length
Response Enter the length in bytes for the macro response buffer.
Buffer
Length
Source Id Enter the Source Id associated with this macro.
Secondary Enter the secondary device address associated with this
Address macro.
Macro Enter the type code for this macro:
Type 01 = Send Primitive
02 = Connect Secondary Device
03 = Disconnect Secondary Device
Primitive Enter the primitive code from the secondary device manual or the
TIWAY I Systems Manual.
Auto Check this box if the macro should be automatically
Enable enabled.
Rept. Check this box if the macro is to be a repetitive macro.