Sony RM-AV2500T - Manual (Page 17)

17 GB
Notes
• If you do not perform learning steps within
two minutes, learning mode ends.
• If you do not perform Step 4 within 10
seconds after Step 3, the display turns back to
the display in Step 2. (All the learnable keys
flash.) In this case, perform Step 3 again
while the display is flashing.
• If “NG” appears while learning, the memory
is full. To free memory, clear learned
functions from keys that you do not use often
(page 19). Then continue the learning steps.
• If you touch a key by mistake in step 4, while
pressing the LIGHT button, press the
mistaken key. Then repeat from Step 3 to
continue learning.
If the Commander does not seem to
be working
If the learned key or button does not operate
properly, teach once again. (For example, if the
volume becomes very loud after pressing the
w
+ button only once, noise may have
interfered during the learning procedure.)
If you set a component code after
learning a signal
If you have programmed any signal for a key
or button using the learning function, that
signal will remain assigned to that key or
button even after you set a component code.
When you teach signals to the
w
or MUTING buttons
•If you have programmed any signal on
the w or MUTING button for
components other than TV and AMP
using the learning function, that signal
will be transmitted only when you
select that component.
•If you have programmed any signal on
the w or MUTING button for TV or
AMP using the learning function, that
signal will be transmitted only when
you select TV or AMP. When you select
other components, the preset volume
control signals for TV or AMP will be
transmitted (for the difference between
visual components and audio
components, see page 21). To use the
learned signal, you need to programme
the w or MUTING button for each
component using the learning function.
When you teach the signals of an
air-conditioner
See the notes on page 37.
Continued