Sony TA-FB920R - Manual (Page 4)

Getting Started
4 GB
Ç L
R
L
R
OUTPUT
LINE
CD
IN
Speaker (L) Speaker (R)
TV or video
deck
Hookup Overview
The amplifier allows you to connect and control the
following audio components. Follow the hookup
procedure indicated for each component that you want
to connect.
To learn the location and name of each jack, see ”Rear
Panel Descriptions” on page 12.
Tape deck DAT deck Tuner
CD player
Before you get started
• Turn off the power to all components before making
any connections.
• Do not connect the mains leads of the various
components until all connections are completed.
• Use the audio connecting cords supplied with each
component for hooking up with the amplifier.
Purchase and use optionally available cords as
required.
• Be sure to make connections firmly to prevent hum
and noise.
• When connecting an audio connecting cord, be sure
to match the R (right) and L (left) jacks of the
amplifier to the R and L jacks on the other
components.
Audio Component Hookups
Overview
Here you learn how to connect your audio components
to the amplifier.
Turntable
Getting Started
MD deck
What cords will I need?
Audio connecting cord (not supplied) (2 for each tape deck,
DAT deck, or MD deck; 1 for other components)
Hookups
The arrow ç indicates signal flow.
CD player
Amplifier
Amplifier Tuner
Tuner
CD player
White (L)
Red (R) Red (R)
White (L)
Ç L
R
L
R
OUTPUT
LINE
TUNER
IN
PROTECTION
U
PHONES
SPEAKERS A • • • • OFF A + B
– 10 + 10
TONE
SUBSONIC
EON LINK
INPUT SELECTOR VOLUME
SOURCE DIRECT 0 10 B
g
SOURCE • • • TAPE1 TAPE2
BASS 0 •
• • – 10 + 10
TREBLE 0 •
• • LEFT RIGHT
BALANCE
•
• •
TAPE MONITOR
TAPE1/DAT EON LINK CD TUNER PHONO AUX TAPE2/MD
LOUDNESS Ø ON ø OFF Ø ON ø OFF
PHONO TAPE1/DAT
EON CONTROL IN TUNER TAPE2/MD CD
y AUX
SPEAKERS
EON CONTROL
R
B
A
L + + – –
R L + + – –
TAPE1/DAT
L
REC OUT IN
IMPEDANCE USE 4–16 Ω
A+B USE 8–16 Ω BI WIRE USE 4–16 Ω
IN
R
L
R
TAPE2/MD REC OUT IN AUX IN CD IN TUNER IN
L
R
PHONO
IN SIGNAL GND y