Sharp MD-C2H User Manual
Page 36
<P=002>
(Continued)
TAPE REC
TAPE REC
1 -
CD PLAY
3
1 -
MD PLAY
3
1 -
MD/CD PLAY
3
CD
MD
MD
CD
2
■
Recording from the built-in radio to a cassette
tape
3
4
2
3
4
1
Tune in to the desired station. (Pages 15 - 16.)
2
Load a blank cassette into the cassette compartment.
●
Wind past the tape leader which cannot be recorded on.
3
Press the TAPE REC
●
button.
●
"TAPE
●
" will flash, and the unit will enter the recording stand-
by mode.
4
Press the
0 6
button.
●
After one side of the tape has finished recording, the recording
will stop automatically.
To stop recording:
Press the
■
button.
●
It is not possible to pause in the recording mode.
Notes:
●
Before recording an AM broadcast, enter the recording stand-
by mode, and then separate the AM loop aerial from the main
unit. Adjust it so that the AM broadcast can be tuned in most
clearly.
●
During recording, you cannot change the station.
■
Recording from CDs or MDs to a cassette tape
(Synchronised Recording System)
When a CD or an MD is played, recording will start automatically.
1
Load CDs or MiniDiscs.
2
Load a blank cassette into the cassette compartment.
●
Wind past the tape leader which cannot be recorded on.
3
Press the CD or MD button to select the desired function.
●
To select the track you want to start recording from, select a
disc using the CD PLAY or MD PLAY button, and press the
■
button to stop the disc. Then, use the jog dial to select the
track.
(Continuous recording will start from the selected track.)
●
Use the APMS function to store the tracks you want to record
in memory. (See page 29.)
4
Press the TAPE REC
●
button.
●
"TAPE
●
" will flash, and the unit will enter the recording stand-
by mode.
●
To cancel the operation, press the
■
button.
5
Press the
0 6
button.
●
Recording will start from the CD or MD whose red frame is
flashing.
●
After the recording has finished, the CD or MiniDisc and the
tape will stop automatically.
To specify the disc to start with and start recording:
①
Perform steps 1 - 3 above.
②
Press one of the CD PLAY 1
0
- 3
0
buttons or MD PLAY
1
0
- 3
0
buttons.
③
Press the
■
button.
④
Press the TAPE REC
●
button, then the
0 6
button.
To stop recording:
Press the
■
button after pressing the
■
button.
●
It is not possible to pause in the recording mode.
Note:
●
When the playing time on a CD or a MiniDisc is greater than
the time you can record on one side of a tape, the unit will
record on one side and then the tape will stop.
In this case, press the
■
button to stop the CD or MiniDisc.
Jog dial
MD-C2H(SUK) TINSE0238AWZZ
35