Sharp MD-C2H - Manual (Page 9)

<P=003>
(Continued)
■
Remote control
● When inserting or removing the batteries, push them towards
the
ë battery terminal.
● Installing the batteries incorrectly may cause the unit to mal-
function.
Precautions for battery use:
● Insert the batteries according to the direction indicated in the
battery compartment.
● Replace all old batteries with new ones at the same time.
● Do not mix old and new batteries.
● Remove the batteries if they are weak or if the unit will not be
used for long periods of time. This will prevent potential dam-
age due to battery leakage.
Caution:
Do not use rechargeable batteries (nickel-cadmium battery, etc.).
Notes concerning use:
● Replace the batteries if the operating distance is reduced or if
the operation becomes erratic.
● Periodically clean the transmitter LED on the remote control
and the sensor on the main unit with a soft cloth.
● Exposing the sensor on the main unit to strong light may in-
terfere with operation. Change the lighting or the direction of
the unit.
● Keep the remote control away from moisture, excessive heat,
shock, and vibrations.
15
15
■
Main unit operation buttons
The main unit operating buttons are common to all functions
(MD/CD/Tuner/Tape).
Some buttons may have no function, depending on the mode
selected.
When a button indicator is lit, the corresponding button can be
used.
■
Jog dial
The jog dial is used to select CD or MD track numbers, adjust
the clock, select a station from memory, and enter characters.
● When the jog dial is turned one step, it will stop at an angle
of about 15
° . This has the same effect as pressing the 3 /
5 or 2 / 4 button on the remote control once.
● If the jog dial is turned further, it has the same effect as press-
ing the
3 / 5 or 2 / 4 button on the remote control
repeatedly.
■ To change the brightness of the display
1
Press the ON/STAND-BY button to turn the power on.
2
Press the DIMMER button.
● The display will become dimmer, and the MD illumination will
go out.
To return to the original brightness:
Press the DIMMER button again.
Note:
● The brightness setting of the display is maintained even after
the unit has entered stand-by mode.
● 2 "AA" size batteries
(UM/SUM-3, R6, HP-7
or similar)
Remote sensor
0.2 m - 6 m
(8" - 20’)
Jog dial
(Main unit) (Remote control)
When bright
When dark
MD-C2H(SUK) TINSE0238AWZZ
8