Philips Saeco ESPRESSO SG200E - Manual (Page 27)

27
English
fig.40
1
2
3
8.1 Description of programming
and maintenance phase keys
To surf inside the menu of the vending machine
use the keys described below.
Key e: ENTER / beverage 05 (fig. 39)
By pressing this key it is possible to access the
following level of programming or maintenance.
Furthermore it is possible to modify or confirm
the values set in the entries of the programming
or maintenance menus.
Key c: CANCEL /beverage 01 (fig. 39)
By pressing this key it is possible to go back to
the previous level of the programming or
maintenance menu. It is also possible to avoid
storing the values of the previously required
modification.
Key ò: DOWN / - sugar (fig. 39)
By pressing this key it is possible to access the
preceding entry inside the same menu level. If
used after requesting to modify a datum, it
decreases its value of this same datum.
Key ñ: UP / - sugar (fig. 39)
By pressing this key it is possible to access the
following entry inside the same menu level. If
used after requesting to modify a datum, it
increases the value of this same datum.
8.2 Programming menu
The structure of the programming menu is
shown in 8.2.2.
8.2.3 describes all the entries in the programming
menu.
8.2.1 Entering the programming
menu
Open the door, insert the key into the safety
switch (fig.18) and press key P1, located on the
CPU card (fig.40, ref. 1) so as to enter the
programming menu.
If no password has been assigned you enter the
programming menu directly.
Important
If a password to enable the programming menu
was assigned to the vending machine,
‘PASSWORD 0000’ will appear on display with
a flashing cursor on the first digit.
Now enter the password using UP and DOWN
keys. Confirm the digit entered pressing the
ENTER key.
To exit the programming menu and return to the
normal operation of the vending machine:
- press key P1 again;
- remove the key from the safety switch to turn
off the vending machine;
- close the door and wait for the self-
configuration process to end.