Sony HT-SF370 - Manual (Page 44)

44 US
Using the power saving
function
(HDMI Pass Through)
If a “BRAVIA” Sync-compatible TV is
connected to the receiver, and the TV is turned
off, HDMI signal transmission stops, and
power consumption is reduced.
1
Press AMP MENU.
“LEVEL” appears on the display.
2
Press V/v repeatedly until “SET
HDMI” appears, then press
or b.
3
Press V/v repeatedly until
“PASS THRU” appears, then
press
or b.
4
Press V/v repeatedly until the
setting you want appears, then
press .
• THRU AUTO: When the TV is turned
on while the receiver is in the standby
mode, the receiver outputs HDMI
signals from the receiver’s HDMI TV
OUT jack. Sony recommends this
setting if you use a TV that is
compatible with “BRAVIA” Sync. This
setting saves power in the standby mode
compared with the “THRU ON” setting.
• THRU ON: When the receiver is in the
standby mode, the receiver continuously
outputs HDMI signals from the
receiver’s HDMI TV OUT jack.
5
Press AMP MENU.
The AMP menu turns off.
Notes
• The power saving function may not work for some
TVs compatible with the “BRAVIA” Sync. In this
case, set “PASS THRU” to “THRU ON”.
• Depending on your components, it may take time
before image or sound is output.
• This function is available only when the Control
for HDMI function is set to on.
O
MENU
AMP
MENU
,
V/v/B/b