Silex technology SDZ-330 - Manual (Page 8)

COLOR CCD CAMERA User’s Manual 15 COLOR CCD CAMERA User’s Manual 14
External Control Connector
Relates to the motion detection output signal.
Zoom and focus functions can be controlled using external siganals.
Power LED
Illuminates when power is supplied.
Video Output Jack
Used to connect an external video monitor in jack.
Communication Control Connector
Used to connect the Remote Controller (Optional). Includes external 'SYNC' signal
input pin, which is used for the line lock function.
Includes the RS-485 communication pin.
Power Input Terminal
Power supply terminal (DC12V±10%).
Frame Ground Terminal
It is the GND terminal of the motion detection signal.
Connection
Connect Video Out Jack to the monitor's Video In jack as shown below.
Connecting to Monitor
CCD Camera Monitor
• Connection methods may vary depending on the video equipment. Please
refer to the model specific instruction manual.
• Connect cables with the unit powered down.
• Set the 75Ω / Hi-Z selection switch as shown below if you have an intermediate
device.
CCD Camera
Intermediate End monitor
Connecting to Power
Connect the power cable to the camera's Power In as shown in the figure
below.
• Connect the power once the installation is complete.
• The wire is polarized. Match '+' and '-' terminals properly.
• Use a DC12V/500mA power source for SDZ-330.
Notes
Power Input Terminal
Frame Ground
Overview