Silex technology SDZ-330 - Manual (Page 9)

COLOR CCD CAMERA COLOR CCD CAMERA User’s Manual User’s Manual 17 16
Connection
Connecting to connection
FOCUS (Input)
ZOOM (Input)
COM
MD (output)
External Control Connector
Communication Control Connector
Connector Signal Level I/O Function
* Communication Control Connector Pin Description .
* EXT. SYNC
* MD (Motion Detection) Output Signal Level (less than 10mA)
* When using the MD function, the 'GND' should be connected to the frame ground.
The camera can be controlled by using external controllers like a Remote
controller. (RS485 Communication)
• Contact an authorized technician for inspection.
Notes
Tele
I
Wide
Far
I
Near
-
O
ZOOM
FOCUS
COM
MD There is motion
+4.0V~+5.0V
3V or 5V
0V
There is no motion
0V 5±0.5sec
COM
-6V~-12V
COM
+6V~+12V
COM
-6V~-12V
COM
+6V~+12V
COM
SCC-3000 Remote Controller
SCC-100, SDZ-160CO
6-Pin Connection
Cable
Number Name Description
1 GND -
2 EXT.SYNC External ‘SYNC’ Signal
3 GND -
Number Name Description
4 TRX + RS-485 Communication
5 TRX - RS-485 Communication
6 Output Power Remote Controller only
* Communication Setting can set the communication setting as shown in the table below.
When you use to connect SCC-100 or SCC-3000, the default sets for SCC-100.
ITEM SCC-100 SCC-3000
MODE Serial Serial
Data Bit 8 bit 8 bit
Bit/Sec 9600bps 9600bps
Parity EVEN NON
CAM ID NO. 0 1~255
RETURN PACKET ENABLE See the SCC-3000 settigs
Min: 500ns
60Hz ± 0.1Hz(NTSC), 50Hz ± 0.1Hz(PAL)