SMC Networks TigerSwitch - Manual (Page 270)

C
OMMAND
L
INE
I
NTERFACE
4-28
Command Mode
Normal Exec
Command Usage
• “super” is the default password required to change the command
mode from Normal Exec to Privileged Exec. (To set this password,
see the enable password command on page 4-37.)
• The “#” character is appended to the end of the prompt to indicate
that the system is in privileged access mode.
Example
Related Commands
disable (4-28)
enable password (4-37)
disable
This command returns to Normal Exec mode from privileged mode. In
normal access mode, you can only display basic information on the
switch's configuration or Ethernet statistics. To gain access to all
commands, you must use the privileged mode. See “Understanding
Command Modes” on page 4-8.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
The “>” character is appended to the end of the prompt to indicate
that the system is in normal access mode.
Console>enable
Password: [privileged level password]
Console#