Woodstock Combination Model User Manual
Page 8
-5-
12.
Do not force tool. The machine will do a safer and better job at the rate for which it was designed.
13.
Use correct tool. Do not force machine or attachment to do a job for which it was not designed.
14.
Wear proper apparel. Do not wear loose clothing, neck ties, gloves, jewelry, keep long hair tied up,
etc.
15.
Remove adjusting keys and wrenches. Before turning the machine on, make it a habit to check that
all adjusting keys and wrenches have been removed.
16.
Use proper extension cord. When using an extension cord, make sure it is less than 100' in length
and that it is in good condition. Use extension cords that are rated Hard Service (grade S) or better,
and that have a conductor size of 16 A.W.G. A drop in line voltage, loss of power and overheating
can result when using an undersized cord. The extension cord should have a ground wire and ground
plug pin, as well.
17.
Keep proper footing and balance at all times.
18.
Do not leave machine unattended. Wait until it comes to a complete stop before leaving the area.
19.
Perform machine maintenance and care. Follow lubrication and accessory attachment instructions
in the manual.
20.
Keep machine away from open flame. Operating machines near pilot lights and/or open flames cre-
ates a high risk if dust is dispersed in the area. Dust particles and an ignition source may cause an
explosion. Do not operate the machine in high-risk areas, including but not limited to, those men-
tioned above.
21.
If at any time you are experiencing difficulties performing the intended operation, stop using the
machine! Then contact our service department or ask a qualified expert how the operation should
be performed.
22.
Habits—good and bad—are hard to break. Develop good habits in your shop and safety will become
second-nature to you.
Operating this equipment creates the poten-
tial for flying debris to cause eye injury.
Always wear safety glasses or goggles when
operating equipment. Everyday glasses or
reading glasses only have impact resistant
lenses, they are not safety glasses. Be cer-
tain the safety glasses you wear meet the
appropriate standards of the American
National Standards Institute (ANSI).