Sony CMT-HP7 - Manual (Page 22)

22 GB
Other operations
Notes
• You cannot activate the Daily Timer and recording
timer at the same time.
• If you use the recording timer and the Sleep Timer at
the same time, the Sleep Timer has priority.
• If the system is on at the preset time, the timer
recording will not be activated.
• The volume is reduced to minimum during
recording.
The demonstration display (display window and
buttons lighting and flashing even when the
system power is off) and the clock display can
be turned off to minimize the amount of power
consumed during standby (Power Saving
Mode).
Press DISPLAY repeatedly while the
system is off until the demonstration
display or the clock display disappears.
To cancel Power Saving Mode
Press DISPLAY repeatedly while the system is
off. Each time you press the button, the display
switches cyclically as follows:
Demonstration display
t Clock display* t
No display (Power Saving Mode)
* The clock is displayed only if you set the clock.
Note
You cannot perform the following operations in Power
Saving Mode.
– setting the clock
– changing the AM tuning interval (except for
European, Russian, Middle Eastern and Philippine
models)
– turning on the system by pressing the function
buttons
Tip
The timer continues to operate in Power Saving Mode.
To Do this
Check the setting 1 Press CLOCK/TIMER
SELECT.
2 Press ./> repeatedly
until “REC SELECT”
appears, then press ENTER.
Change the setting Start over from step 1.
Cancel the timer 1 Press CLOCK/TIMER
SELECT.
2 Press ./> repeatedly
until “TIMER OFF” appears,
then press ENTER.
Display
Turning off the display
— Power Saving Mode