Sony CMT-HP7 - Manual (Page 28)

28 GB
CD/MP3 player
“LOCKED” appears.
• Contact your Sony dealer or local authorized Sony
service facility.
The disc does not eject.
• You cannot eject the disc during CD Synchro
Recording. Press x to cancel the CD Synchro
Recording, then press any one of the buttons
(DISC 1 Z – DISC 5 Z on the unit) to eject the
disc.
• Consult your nearest Sony dealer.
Play does not start.
• Check whether a disc is loaded (The DISC
indicator lights up when a disc is loaded).
• Wipe the disc clean (page 31).
• Replace the disc.
• Load the disc that this system can play (page 4).
• Load the disc correctly.
• Load the disc in the player with the label side up.
• Remove the disc and wipe away the moisture on
the disc, then leave the system turned on for a few
hours until the moisture evaporates.
• Press N on the remote (or CD N on the unit) to
start play.
The sound skips.
• Wipe the disc clean (page 31).
• Replace the disc.
• Try moving the system to a place without
vibration (e.g., on top of a stable stand).
• Try moving the speakers away from the system, or
placing them on separate stands. When you listen
to a track with bass sounds at high volume, the
speaker vibration may cause the sound to skip.
Play does not start from the first track.
• Press PLAY MODE repeatedly until both “PGM”
and “SHUF” disappear to return to Normal Play.
MP3 audio track cannot be played back.
• Recording was not performed according to the
ISO 9660 level 1 or level 2 format, Joliet or
Romeo in the expansion format.
• The MP3 audio track does not have the extension
“.MP3”.
• The data is not stored in MP3 format.
• Discs containing files other than MPEG 1 Audio
Layer-3 files cannot be played.
MP3 audio tracks take longer to play back than
others.
• After the system reads all tracks on the discs,
playback may take more time than usual if:
– the number of albums or tracks on the disc is
very large.
– the album and track organization structure is
very complex.
The album title, track title and ID3 tag do not
appear correctly.
• Use a disc that conforms with ISO 9660 level 1,
level 2, Joliet or Romeo in the expansion format.
• The disc ID3 tag is not ver. 1 (ver. 1.0 or 1.1).
Tuner
Severe hum or noise/stations cannot be
received.
• Set the proper band and frequency (page 13).
• Connect the antenna properly (page 6).
• Find a place and an orientation that provide good
reception, then set up the antenna again. If you
cannot obtain good reception, we recommend you
connect a commercially available external
antenna.
• The supplied FM lead antenna receives signals
along its entire length, so make sure you extend it
fully.
• Locate the antennas as far away from the speaker
cords as possible.
• Try turning off surrounding electrical equipment.
A stereo FM program cannot be received in
stereo.
• Press REPEAT/FM MODE on the remote until
“STEREO” appears.