Sharp PG-A10X - Manual (Page 60)

-56
Info
• If the temperature warning indicator illuminates, and the power turns off, follow the above possible solutions
and then wait until the projector has cooled down completely before plugging in the power cord and turning
the power back on. (At least 5 minutes.)
• If the power is turned off and then turned on again, as during a brief test, the lamp replacement indicator may
be triggered, preventing the power from going on. Should this occur, disconnect the power cord from the wall
outlet and plug it back in again.
• If you want to clean the air vents during projector operation, be sure to first press
on the projector or
on the remote control and after the power has turned off and the cooling fan has stopped, then clean the
vents.
• Do not unplug the power cord after the power has been turned off and while the cooling fan is running. The
cooling fan runs for about 90 seconds.
Maintenance Indicators