Important saf et y instructions – Spirit XG400 User Manual
Page 6
2
e
Glide Trainer
XG400
Important Saf
et
y Instructions
WARNING - Read all instructions before using this appliance.
If using the optional power supply:
DANGER - To reduce the risk of electric shock disconnect your Spirit e•Glide Trainer from the
electrical outlet prior to cleaning and/or service work.
WARNING - To reduce the risk of burns, fire, electric shock, or injury to persons, install
the e•Glide Trainer on a flat level surface with access to a 110-volt, 15-amp grounded outlet with
only the e•Glide Trainer plugged into the circuit.
DO NOT USE AN EXTENSION CORD UNLESS IT IS A 14AWG OR BETTER, WITH ONLY
ONE OUTLET ON THE END:
Do not operate e•Glide Trainer on deeply padded, plush or shag carpet. Damage to both
carpet and e•Glide Trainer may result.
Keep children away from the e•Glide Trainer. There are obvious pinch points and other
caution areas that can cause harm.
Keep hands away from all moving parts.
Never operate the e•Glide Trainer if it has a damaged cord or plug. If the e•Glide Trainer is
not working properly, call your dealer.
Keep the cord away from heated surfaces.
Do not operate where aerosol spray products are being used or where oxygen is
being administered. Sparks from the motor may ignite a highly gaseous environment.
Never drop or insert any object into any openings.
Do not use outdoors.
To disconnect, turn all controls to the off position, then remove the plug from
the outlet.
Do not attempt to use your e•Glide Trainer for any purpose other than for the purpose it is
intended.
The hand pulse sensors are not medical devices. Their purpose is to provide you with an ap-
proximate measurement in relation to your target heart rate. Use of a chest transmitter strap
(sold separately) is a much more accurate method of heart rate analysis . Various factors, in-
cluding the user’s movement, may affect the accuracy of heart rate readings. The pulse sensors
are intended only as exercise aids in
determining heart rate trends in general.
Wear proper shoes. High heels, dress shoes, sandals or bare feet are not suitable for use on
your e•Glide Trainer. Quality athletic shoes are recommended to avoid leg fatigue.
SAVE THESE INSTRUCTIONS - THINK SAFETY!