Spirit XG400 - Manual (Page 9)

5 e
Glide Trainer
XG400
1. Feed the computer cable (95) up through the console mast tube (pulse grip posts at the top) with the end of
the twist tie that is attached to it.
2. Place the console mast tube onto the mating plate of the main frame; Be careful not to pinch the Computer
cable between the console mast and the main frame plates during assembly.
3. Secure the console mast in place with the four stainless steel bolts (42) and split washers (50).Make sure the
bolts are securely tightened using the 8mm Allen wrench (108).
4. Attach the console (78) to the bracket with four Phillips Head Screws (112) using the Phillips Head Screw
Driver (107).
5. Attach the hand brake lever (90) to the handlebars as follows:
HARDWARE
STEP 1: Console Mast
#42. M10 x 20mm
Stainless Steel Bolt
(4 pcs)
#50. M10
Split Washer
(4 pcs)
ƒ Remove the screw that is threaded into the nut on the backside of the hand brake with the Phillips head
screw driver (107)
ƒ Place the hand brake bracket around the front of the right handlebar vertical tube, then insert the bolt
through the back of the bracket and thread back into the nut. Tighten with the Phillips head screw driver
(107)
#112. M5 x 12mm
Phillips Head Screw
(4 pcs)