Sherbourn Technologies PT-7010A - Manual (Page 23)

23
Connection Diagram 9:
Connecting an Amplifier
(Main Zone for a 5.1 Configuration)
In this configuration the PT-7010A is connected to 5 channels of amplification via
balanced XLR connections. The sixth output would connect to the input of a powered
subwoofer. If using more than one subwoofer, use the pass through output on one
subwoofer to route the input signal to the additional subwoofer(s). If you choose to
connect the remaining two connections (LEFT and RIGHT SURROUND BACK)
you will need a 7 channel amplifier like the one shown here - the Sherbourn 7/2100A
- and you must enable the channels through the SPEAKER SIZE menu of the PT-
7010A remote control.
This configuration shows the MAIN ZONE 5.1 channel
connections to a multi-channel amplifier. You may use
single ended RCA audio cables or the preferred balanced
XLR audio connections. The advantage of the XLR
balanced connections is that they have a much higher
rejection to any radiated noise from AC line cord
interference. Also note the connection of the 12 VDC
trigger to turn the amplifier on.