Sherbourn Technologies PT-7010A - Manual (Page 8)

8
PT-7010A
Front Panel Features
1
Power Button
This turns the PT-7010A on or off. It is a non-latching
momentary button. If you press Z2 first, it can turn on
Zone 2 (even if the Main Zone is off).
IMPORTANT- Please note the PT-7010A requires
initialization after the power cord is plugged into the AC
receptacle. Push and hold the power button for
approximately. 5 seconds. The unit will power up after
this small delay. The second push of the power button
will turn the unit off and after this the unit will turn on
and off in a normal fashion.
2
IR Receiver Window
This window should be clean and free from obstruction
for the remote control to work correctly.
3
Processor Display
This soothing blue display shows which input is selected,
the tuner frequency, volume level, and other useful
information.
4
Volume Knob
Rotate this manual control clockwise to increase the
volume. The dB level will appear in the front panel display.
When turning on a new source, make sure the level is low,
such as -80 dB and increase it slowly. The dB display
becomes less negative as the volume increases. The PT-
7010A volume control is velocity sensitive. If turned
slowly, the volume will change in small increments. If
rotated quickly, level change will be made in larger
increments.
Note: When the PT-7010A is turned on, it has a deliberately
slow and smooth volume ramp from silence, up to the level
that was set when the unit was last turned off. It can also
be programmed to come up to a preset volume you have
selected, rather than the previous volume. The knob does
not turn when volume is operated from the PT-7010A
remote.
5
Z2 (Zone 2)
Any changes you make after pressing this, will affect Zone
2 and not the Main Zone. For example, press Z2, then
POWER to turn on Zone 2, then adjust the Volume and
select an input. Press Z2 again to revert back to Main Zone
operation. It will also revert back after a short period of
no activity.
Note: If Zone 2 has not been enabled this button has no
effect. The unit is shipped with Zone 2 disabled.
6
Input Select Buttons
Use these controls to select the source that you want to
listen to and/or view. Using the On Screen Display (OSD)
IN-PUTS menu, each input can be adjusted in level so
that all the inputs have similar volumes. Each input can
also be set to enter a desired surround mode whenever
that input is selected.
Note: After you have selected an input, you should check
that the PT-7010A is set to the desired surround mode (or
the stereo mode).
7
Mode Up/Down (Mode Buttons)
These buttons allow you to step up or down through the
various sound play-back modes.