User’s guide – Sony SX-215 User Manual

Page 81

Advertising
background image

User’s Guide

WPA Group Key
If the WPA Group Key mode is enabled, then group keys may be used for data link encryption.
The default is disabled.

--------------------------------------------------------------------------------

Command Line Console Configuration

Go to the command prompt on your PC and type TELNET ipaddress (where ipaddress is the IP Address
configured in the print server). You should get a # prompt, type in the password (default is ACCESS, this
will not echo on your screen as you type it). Hit Enter a couple times until you get a Local> prompt. This is
where you can type your commands. Type HELP to get a list of commands.

The following console commands can be used to configure your network security settings:

SH NW

Displays summary network information

sample output:
WiFi Mode = INFRASTRUCTURE
WiFi SSID: silex
Speed = 11
Regulatory Domain = 704
WiFi FW Ver = 1F 1.7.1
AP density = LOW
TTLS is Disabled
WEP is Disabled
Link DOWN

SET NW AUTHtype

Sets WLAN Authentication type

SET NW AUTHtype [OPEN |SHARED | TLS | TTLS | LEAP | PEAP | PSK]
(default = Open System)

SH NW AUTH

Shows the wireless authentication type

sample output:
Authentication type= OPEN SYSTEM

SET NW CHannel

Sets WLAN ad-hoc channel number

SET NW CHannel n
n = 1-11 (default = 11, this value is ignored in Infrastructure mode)

SET NW ENC

Sets WLAN Encryption Mode. Supported modes are none, 64 bit WEP, 128 bit WEP, WPA (TKIP), and
WPA2 (AES/CCMP).

Document #40181-420 Rev. B

81

Advertising