Savin 2535P - Manual (Page 34)

Configuring the Network with the Operation Panel
23
2
B
Press
{{{{System Settings}}}}.
C
Press [Interface Settings].
The following screen appears on the panel display.
D
Make sure that the [Network] key is pressed.
The following screen appears on the panel display.
E
Press [Effective Protocol].
The following message appears on the panel display.
Note
❒ Consult the network administrator for help with these settings.
❒ You must configure IP Address for using TCP/IP protocol. You don't have
to configure it if Networkboot is DHCP.
❒ Press [Invalid] for protocols that you don't use.
❒ Press [Effective] for TCP/IP protocol when you use pure IP of NetWare 5.
Limitation
❒ You need to have PostScript 3 module for AppleTalk.
AdonisC2-sysEN122F_FM.book Page 23 Thursday, February 1, 2001 1:46 PM