Sennheiser S-MCD 3000 HP - Manual (Page 60)

60
10 Reprogramming frequencies
In “Production” mode, a control panel always shows the frequency to which the receiver is set. You can
see this in “Configuration” mode because the frequency value is shown as “---.---”. If you wish to
reprogram the frequency of a receiver for one or several scenes, please carry out the following steps:
1. In “Configuration” mode, click onto the rider of the scene in which
you would like to reprogram the receiver frequency.
2. Double-click onto the control panel of the receiver in question.
The “Panel Configuration” window is opened.
3. Press the “Get Freq. list” button to display all frequencies stored
in the receiver.
4. Double-click onto the desired frequency in the list.
The frequency is then taken over into the “new Frequency” field.
5. Close the “Panel Configuration” window with OK.
The new frequency is now displayed in the control panel.
If you now call up the scene in question in “Production” mode, the receiver is automatically reprogrammed
to the new frequency.