Sennheiser S-MCD 3000 HP - Manual (Page 70)

70
19 RF recorder
1 The RF recorder
The dialogue gives you various different editing options. Buttons with a grey background cannot be
pressed in the current state. For example, you cannot stop a recording if it has not been started. This
just about excludes wrong operation. You can operate the RF recorder in two operating modes. The
program starts with the default setting “RF Level Recorder”. This is for recording measured values over
a certain period of time. You can switch over to the “RF Spectrum Analyzer” via the selection list (see
the following Fig. „RF recorder“) in the centre of the top margin. This mode is for recording measured
data over a defined frequency range.