Sanyo PLC-EF60 - Manual (Page 16)

16
Preparation
This wireless remote control uses radio frequency signal. You can switch four frequency channels prepared and select a
remote control ID from eight IDs. The Remote Control Channel selection prevents radio frequency interference from the
other equipment and the Remote Control ID selection allows you to operate several projectors with their respective remote
controls without mutual interference among those projectors.
Wired Remote Control Transmitter
The remote control can be used as a wired remote control. When
interference between the projector and other equipment occurs or
the projector is used in a place where the operation of radio
equipment is restricted, connect the remote control and the
projector with the remote control cable provided. Connected with
the remote control cable, the remote control does not emit radio
signal.
Remote Control Channel and ID Setup
Initial Remote Control Channel and ID are CH1 and ID1. When
you change the setting, set a Channel first, and then an ID.
Channel and ID settings for the remote control should be the
same as those for the projector. When changing the CH and ID
settings to the remote control, do it to the projector as well. Refer
to "Remote Control " in Setting menu on page 53.
Should you be lost at which CH and ID are currently set, initialize
the Channel and ID once, and set them again.
With holding down the CH button, press the SELECT button.
The Remote Control Channel switches sequentially for one
pressing the SELECT button. (See Table1 on next page.)
With holding down the CH and ID buttons together, slide the
REMOTE RESET/ON/ALL-OFF switch to REMOTE RESET,
and then to ON. The initial Channel and ID are CH1 and ID1.
(p15)
1
MENU MENU
C A N C E L
INFO AUTO PC
SCREEN FREEZE
P-TIMER SOUND
REMOTE
VOL.
MUTE
CH
ID
INPUT 4
INPUT 1
INPUT 2
INPUT 3 INPUT 5
REMOTE RESET ON ALL OFF
L E N S S H I F T
K E Y S T O N E
S H U T T E R D . Z O O M
Z O O M F O C U S
O N - O F F
While pressing the CH/ID
button, press the SELECT
button number of times
corresponding to the
remote control CH/ID.
MENU
C A N C E L
INFO AUTO PC
SCREEN FREEZE
P-TIMER SOUND
REMOTE
VOL.
MUTE
CH
ID
L E N S S H I F T
K E Y S T O N E
S H U T T E R D . Z O O M
Z O O M F O C U S
O N - O F F
ID button
CH button
SELECT button
✔
Note:
Remote Control Channel and ID cannot be initialized separately.
Set the Remote Control Channel
Set the Remote Control ID
2
With holding down the ID button, press the SELECT button.
The Remote Control ID switches sequentially for one
pressing the SELECT button. (See Table2 on next page.)
Initialize the Remote Control Channel and ID
Remote Control Transmitter