Sanyo PLC-EF60 - Manual (Page 21)

21
Installation
Terminals to connect AC power cord and other equipment are
located in the front part of the projector for easy setup. The
terminal area is masked with the front cover to protect them from
dust and others, and hide messy cable connections.
The projector's front terminal area has two replaceable Interface
board slots. The projector's functions can be extended by
installing the optional interface boards into the terminal slots. A
vacant slot (Input 5) is provided in your purchasing the projector.
Install or replace the optional interface boards as follows:
Remove 2 screws from an interface board installed in the
projector.
Pull out the interface board by holding its handles and remove it.
Then, insert another board along with the guides inside the slot to
fit the socket into the inside plug. Tighten screws to secure the
board.
Screws
Socket
Terminal board
✔
Notes On Ordering or Using Optional Interface Boards:
When ordering or using the Optional Interface Boards, contact your sales dealer and
tell the Model no. of your desired board (p75) and Option Control No. shown in the
Information menu. (p31and 61)
✔
Note:
When installing or removing the interface board, disconnect the AC power cord from
the AC outlet before doing it.
Remove and replace the front cover following the procedure
below:
Pushing the button A on right side of the front cover, pull the part
forward to remove the front cover.
To replace the front cover onto the projector, insert back the left
part of the cover into the projector and then push the entire cover
back the projector. Make sure the front cover is locked with the
button A and fit on the projector.
Pull this part forward
with pushing button A.
A
Interface Board Slots
Caution
Do not push hard or give a strong shock to the
cover. It may cause damage to it.
Terminals
Front cover
Connection Terminals
Installation
Option Control No.
See Option Control No. in the Information menu
to order any optional interface board.