Sanyo PLC-EF60 - Manual (Page 49)

49
Screen Setting
Press the SELECT button at the D. Zoom –. The message “D.
Zoom –” is displayed. Press the SELECT button to compress
the image size.
D. Zoom –
Ceiling
Rear
When this function is “On,” the picture is top/bottom and left/right
reversed. This function is used to project the image from a ceiling
mounting the projector.
When this function is “On,” the picture is left/right reversed. This
function is used to project the image to a rear projection screen.
Press the SELECT button at the D. Zoom +. The message “D.
Zoom +” is displayed. Press the SELECT button to expand the
image size. And use the Control pad to pan the image. The
Panning function can work only when the image is larger than
the screen size.
D. Zoom +
Ceiling
Rear
✔
Note:
• The True and D. Zoom +/– cannot be selected when projecting AV sources or
selecting “480i”, “575i”, “480p”, or “575p” in the System menu (p39~40).
• This projector cannot display any resolution higher than 1600 X 1200. If your
computer’s screen resolution is higher than 1600 X 1200, reset the resolution to
the lower before connecting the source to the projector.
• The image data in other than XGA (1024 x 768 for PLC-XF60) or SXGA (1400 x
1050 for PLC-EF60) is modified to fit the screen size in initial mode.
• The panning function may not operate properly if the computer system prepared in
the PC Adjust Menu is used.
D. Zoom
D. Zoom
This function corrects distortion of a projected image. Press the
SELECT button at Keystone twice and The keystone dialog box
appears. Adjust keystone with the Control pad.
Press the SELECT button at Keystone and select either Store or
Reset with the Control pad, and then press the SELECT button to
fix the selection.
Store . . . .stores the keystone adjustment even if the AC
power cord is disconnected.
Reset . . . . .resets the keystone adjustment when the AC power
cord is disconnected.
Keystone
Keystone
Scr
een Setting
✔
Note:
To exit the D. Zoom +/– mode, try the followings:
• To return to the normal screen, change Input, or change the screen size.
• To exit the panning mode, press any button except the D. ZOOM button, the
SELECT button, and the CH and ID buttons.